铺设路面加筋网的下承层应表面平整、压实，并清除表面坚硬凸出物。
The laying of the pavement reinforcement network should be under the surface layer formation, compaction, and removal of hard surface protrusions.
路面加筋网铺设前应按设计幅宽在铺筑层画出白线，用铁钉固定加筋网端部（每米宽用钉8根，均匀距离固定）。
Pavement reinforcement before the laying of the width of the pavement should be drawn in the pavement layer to draw white lines, with nails fixed end of the reinforcement net (8 meters wide with nails, uniform distance from the fixed).
固定好加筋网端部后，人工将加筋网缓缓向前拉铺，每10米长人工拉紧和调直一次，直至一卷铺完，再铺下一卷，操作同前。
After fixing the end of the reinforced net, the artificial net will be pulled forward slowly. Every 10 meters long will be tightened and straightened until the roll is finished. Then roll the next roll.
路面加筋网铺设时，必须拉紧展平插钉固定，并与路基面密贴不得有皱褶扭曲。
When laying the pavement reinforcement mesh, it must be tightened and flattened and fixed with the nails, and the pavement surface shall not be wrinkled and twisted.
铺完一卷用压路机沿前进方向从起点碾压一遍即可铺设后续加筋网。
Paved a roll with the roller along the way from the starting point of rolling again to lay the follow-up reinforcement.
铺完一卷后再整体检查一次铺设质量，然后再铺下一段，铺设时接缝搭接长度10cm~15cm，并用铁钉或木偰固定后再继续铺设。
After laying out a volume and then check the overall quality of a laying, and then pave the next section, when the lap laying lap length of 10cm ~ 15cm, and fixed with nails or wood and then continue laying.
